2010-1001 DMD Chip – 0.98″ 2K DC2K Digital Cinema DLP Chip (Red Spectrum)
The Texas Instruments 2010-1001 is a professional-grade 0.98-inch DMD (Digital Micromirror Device) chip designed for 2K DLP Cinema™ projectors. It is part of TI’s DC2K (Digital Cinema 2nd Generation) DMD family, which TI released in 2007 and later used as the standard imaging engine for DCI-compliant digital cinema projectors.
This chip is specifically designated for the RED spectrum in a 3-chip DLP Cinema system. It works alongside two complementary chips—2010-1000 (Green Spectrum) and 2010-1002 (Blue Spectrum)—to handle the red, green, and blue color channels individually. The triple-DMD design is a hallmark of high-end digital cinema projectors: each primary color is routed to its own DMD, then recombined and projected through the lens.
With a native resolution of 2K (2048 × 1080 pixels), a ±12° micromirror tilt angle, and a native contrast ratio exceeding 2000:1, this DMD delivers the brightness and sharpness required for theatrical projection in screens up to 50 feet / 15 meters wide.
If your cinema projector is producing a single stuck color cast (for example, a persistent pink / red tint across the entire image), persistent stuck pixels that multiply over time, or fails its start‑up self‑check, the DMD chip for that particular color channel is likely failing. Replacing the defective 2010-1001 with this genuine Texas Instruments chip restores accurate color reproduction and a clean, artifact‑free picture.
Known Cinema Projectors That Use This Chipset
- Barco Alchemy DP2K‑20C – 18,500 lumens, screens up to 65ft (20m) wid
- Christie CP2215 – ~15,000 lumens, screens up to 50ft (15m)
- Christie CP2315 / CP2420‑RGB – 0.98″ mDC2K 3‑chip DLP Cinema®
- NEC NC1600C – 17,000 lumens, screens up to 65ft (20m)
- Many other DC2K‑based 2K digital cinema projectors from these brands also use the 2010‑100x family as their optical engine.
Critical Compatibility Note
The 2010‑1000 / 1001 / 1002 are color‑specific chips certified for use in 3‑chip DLP Cinema systems. Do not assume a physically similar 0.98‑inch 2K DMD will be a drop‑in replacement. Replacing a single DMD without verifying its designated color channel will cause the projector to fail its calibration self‑check or permanently distort color timing.
Important Reminders Before Ordering
- ✅ Verify that your faulty DMD has the exact part number 2010-1001 printed on its top surface.
- ✅ Check that your projector uses a 3‑chip DLP Cinema® optical system (it will have three DMDs: 2010‑1000 / 1001 / 1002).
- ✅ Be aware that blue‑channel DMDs historically fail at a significantly higher rate (approximately 10 times more often) than the red‑channel 2010‑1001 due to differences in thermal load and operating conditions.
- ✅ If you suspect multiple DMD failures, consider testing or replacing all three chips to guarantee balanced color reproduction.
- ✅ For the strongest compatibility guarantee, send us a clear, well‑lit photo of your original DMD chip. We will confirm the match before you order.
Restore your professional digital cinema projector with the genuine Texas Instruments 2010‑1001 DC2K DMD chip—engineered for the precision, reliability, and longevity that commercial cinema demands.
