8060‑6318W DMD Chip – Flat Contact Type for 800×600 Projectors
If your older DLP projector is showing a growing number of white dots that eventually look like falling snow, the DMD chip is likely failing. This 8060‑6318W DMD chip is a direct replacement for projectors.
This chip is commonly found in legacy 800×600 resolution projectors. When it burns out, you’ll see scattered white pixels that multiply over time, ruining the image. Swapping it with a fresh 8060‑6318W restores a clean, dot‑free picture.
Typical failure signs:
- White dots that start small and gradually increase
- Snow‑like pattern, especially on dark backgrounds
- No image or distorted output even when the lamp works
Replacing the DMD chip requires careful handling of the flat contact surface and proper alignment. If you’re comfortable opening your projector, this is a cost‑effective repair that brings an old 800×600 machine back to life.
Note: Confirm your original DMD part number before ordering. interchangeable with 8060-6319W. Send us a photo if you’re unsure.
