Original Panasonic PT‑AE700E LCD Module – Complete Unit (3 LCD Panels + Prism) – Part L3D07H‑56G01
Factory pre‑aligned – no individual panel adjustment needed. This is a genuine Panasonic complete LCD module (part L3D07H‑56G01) for the PT‑AE700E home cinema projector. The module includes all three LCD panels (red, green, blue) and the polarising prism, factory‑mounted and pre‑aligned as a single assembly. Installation is purely mechanical. You do not need to adjust convergence, focus, or panel registration. Simply remove the old optical block and install this unit.
The module is new old stock / genuine Panasonic spare part. It is factory‑calibrated, so after replacement you get perfect colour alignment immediately. This is the correct repair solution for failed polarisers, burnt LCD panels, prism separation, or optical block damage – without the complexity of individual panel alignment.
| Compatible Model | Panasonic PT‑AE700E (720p home cinema / 3LCD projector) |
|---|---|
| Part Number | L3D07H‑56G01 (complete LCD block + prism assembly) |
| Condition | New Old Stock – Genuine Original Panasonic Part |
| Included Items | Full LCD module with prism (3 pre‑aligned LCD panels, polarisers, and dichroic prism). No loose panels or separate components. |
Why replace the whole LCD module (L3D07H‑56G01) on PT‑AE700E
Panasonic’s PT‑AE700E is a classic 720p home cinema projector. Over time, the optical block can suffer from:
- Polariser degradation – yellow or brown tint, uneven colours, or complete colour loss.
- LCD panel failure – dead pixels, vertical banding, or dark streaks.
- Prism separation / delamination – visible rainbow patterns or haze inside the optical block.
- Dust contamination inside the sealed prisms – spots that cannot be cleaned without full disassembly.
Attempting to replace individual LCD panels on this model requires hours of delicate convergence alignment. The L3D07H‑56G01 module eliminates that – you swap the whole pre‑aligned block and the projector is ready to go.
What this module includes
- All three high‑temperature polysilicon LCD panels (red, green, blue).
- Factory‑attached polarisers (input and output).
- Dichroic prism assembly (colour recombination).
- Mounting frame and alignment pins.
- Flex cables ready to connect to the main driver board.
Installation notes
Swapping the LCD module requires opening the PT‑AE700E and removing the complete optical engine. This is a mechanical job – no calibration tools or test patterns are needed. However, dust management is critical. The module is sealed at the factory, but the cavity around it is not. Work in a clean, low‑dust environment. Flex cables attach exactly as the original.
Important: Take clear photos of the original cable routing and screw positions before disassembly. The PT‑AE700E service manual is recommended for exact disassembly steps but not included.
Restore your PT‑AE700E to original optical quality
The PT‑AE700E was a respected home cinema projector in its day. If your unit has colour fade, dimness, or prism issues, this genuine Panasonic LCD module brings it back to factory‑fresh performance. It is far cheaper than buying a used projector of unknown condition. This direct replacement keeps your classic 720p home theatre running for years.
Note: L3D07H‑56G01 is specific to the PT‑AE700E. It does not fit PT‑AE700 or PT‑AE900E without modification. Send us a photo of your original optical block if you are unsure.
