Vivitek H1080 Color Wheel Replacement | Genuine spare parts | Also fits H1081, H1082

Original Vivitek H1080 Projector Replacement Color Wheel – Genuine 6‑Segment RYGCMB (6x Speed, Nidec Motor)

If your Vivitek H1080 (or H1081, H1082) home cinema projector has started making a grinding or whining noise, showing weird colors, flickering, or shutting down seconds after power‑up — don’t scrap it. In most cases, the problem is a worn‑out color wheel. This 100% original, genuine Vivitek spare part is the exact replacement you need to bring back that rich, cinematic image.

This is not a refurbished pull or a cheap copy. It’s a brand new, factory‑sealed Vivitek color wheel with a Nidec motor, 6x speed, and 6 segments (RYGCMB – Red, Yellow, Green, Cyan, Magenta, Blue). The RYGCMB sequence is designed for a wide color gamut – magenta and cyan deliver deeper reds, more natural skin tones, and vibrant greens. The 6x rotation virtually eliminates the rainbow effect, which is critical for long movie sessions. Every detail – glass thickness, mirror coating, dynamic balance – matches Vivitek’s original service parts.

Why color wheels fail – and why you need a genuine one

Over time, dust builds up inside the projector, gets onto the color wheel, and accelerates bearing wear. The motor starts to whine or grind. The wheel can go out of balance, causing flicker, rainbow effects, or complete self‑test failure (auto shut‑down). A generic replacement might use a cheaper motor or wrong segment order (e.g., RYGCWB or RGBRGB), which will cause the same problems again – or worse, permanently wrong colors. This genuine Vivitek RYGCMB 6x Nidec wheel has factory‑spec bearings, precise balance, and the exact timing your H1080 expects. No guessing – it just works.

What a new genuine color wheel fixes

• Auto shut‑down – projector powers off a few seconds after the lamp lights (failed self‑test).
• Mechanical noise – constant whining, grinding, or rattling that changes with brightness.
• Image flicker or rainbow artifacts – flashing picture or color trails on fast motion.
• Abnormal colors – skin tones look green, reds turn orange, whites have a pink tint.

Replace the old wheel with this genuine Vivitek part, and your projector will run like new – quiet, stable, and with accurate, vibrant colors.

Restore your Vivitek H1080 – not the whole projector

Swapping the color wheel is a straightforward DIY repair for anyone comfortable opening a projector case. The new wheel mounts exactly to the original screw holes, and the flex cable clicks right in. The Nidec motor spins quietly at 6x speed, the factory balance kills vibration, and the RYGCMB mirror coating restores correct color decoding. Don’t scrap a perfectly good DLP chip and lamp – just change the one part that wears out. Bring your home cinema back to life and enjoy movies the way they were meant to look.

Note: Compare this wheel’s diameter and segment pattern with your old one. Send us a photo if you’re unsure about compatibility.